Description
SW Flex NEC 76F00xx MASTER
This software package includes protocols for work in JTAG AUD on engine control units that mount NEC76F00xx microprocessors. This SW package makes it possible to communicate with the supported units through the JTAG port so in this case, it is necessary to open the control unit.
SW Flex NEC 76F00xx MASTER
SW Flex NEC 76F00xx MASTER
The Flex AUD for NEC 76F00xx SW Package allow full read and full write of the ECU, including each of the memories stored inside the control unit without any encryption. Other toolmakers may name this protocol as JTAG NEC 76F00xx. Tuning, clone and restoring backup are no issue at all, and can be done shortly. Reading times have been tested around a minute in total, depending on ECU model. Writing times are also very short, less than two minutes in general. If you are a previous owner of MAGP1.2 or MAGP1.12 (X17), this new protocol is totally free of charge. Anyone else can contact Sales Department to purchase this protocol.
